ROBERT L. EHRLICH, JR., Governor                                 Ch. 5

(1)      STEAM;

(2)      INDIRECTLY RADIATING HOT AIR;

(3)      HOT WATER; OR

(4)      ANY OTHER MEANS APPROVED BY THE STATE FIRE PREVENTION
COMMISSION.

(F)     ELECTRICAL WIRING AND LIGHTING.

(1)      ALL ELECTRIC WIRING IN A FIREWORKS PLANT SHALL BE
PERMANENT AND INSTALLED IN APPROVED CONDUITS.

(2)      ALL ELECTRICAL SERVICE SHALL COMPLY WITH APPLICABLE
ELECTRICAL CODES.

(3)      TEMPORARY OR LOOSE ELECTRIC WIRING OR EXTENSION LIGHTS
MAY NOT BE USED EXCEPT:

(I)      DURING REPAIR OPERATIONS WHILE USING APPROVED
TEMPORARY EXTENSIONS; AND

(II)     AFTER THE AREA HAS BEEN CLEARED OF ALL EXPLOSIVE
COMPOSITION AND WASHED OF DUST.

(4)      EACH FIREWORKS PLANT SHALL HAVE A MASTER SWITCH THAT:

(I)      IS LOCATED AT THE POINT WHERE ELECTRIC CURRENT
ENTERS THE FIREWORKS PLANT; AND

(II)     ON BEING OPENED, IMMEDIATELY CUTS OFF ALL ELECTRIC
CURRENT TO THE FIREWORKS PLANT.

(5)      OTHER THAN IN A WAREHOUSE, AN OPEN KNIFE SWITCH MAY NOT
BE USED INSIDE A BUILDING OF A FIREWORKS PLANT.

(6)      ARTIFICIAL LIGHTING IN A FIREWORKS PLANT SHALL BE PROVIDED
BY ELECTRIC, VAPOR-PROOF, KEYLESS LAMPS.

(G)     EXITS.

(1)      EXCEPT AS PROVIDED IN PARAGRAPH (2) OF THIS SUBSECTION, EACH
BUILDING SHALL CONTAIN:

(I)      AT LEAST TWO EXITS FOR EACH WORK AREA; AND

(II)     AT LEAST TWO EXITS FROM THE BUILDING.

(2)      EACH SMALL BUILDING WITH A DESIGNATED CAPACITY OF ONE
INDIVIDUAL MAY HAVE ONLY ONE EXIT.

(3)      EACH EXIT SHALL BE AT LEAST 30 INCHES WIDE.

(4)      EXITS SHALL BE LOCATED:

- 441 -