HARRY HUGHES, Governor                                     1793

(D)  On vehicles equipped with more than one tail lamp, the
lamps shall be mounted on the same level and as widely spaced
laterally as practicable.

[(b)] (E) Every tail lamp on every vehicle shall be located
at a height of not more than 72 inches nor less than 20 inches.

[(c)] (F) Either a tail lamp or a separate lamp shall be
constructed and placed to illuminate, with a white light, the
rear registration plate and render it clearly legible from a
distance of 50 feet to the rear. Any tail lamp or tail lamps,
together with any separate lamp or lamps for illuminating the
rear registration plate, shall be wired to be lighted whenever
the head lamps or auxiliary driving lamps are lighted.

22-210.

(a) Reflectors required by § 22-208 of this subtitle shall
be mounted at a height of not more than 60 inches nor less than
15 inches above the ground on which the vehicle stands. However,
if the highest part of the permanent structure of the vehicle is
less than 15 inches, the reflector at that point shall be mounted
as high as that part of the permanent structure will permit.

(b)  The rear reflectors on a pole trailer may be mounted on
each side of the bolster or load.

(c)  Any required red reflector on the rear of a vehicle may
be incorporated with the tail lamp, but the reflector shall meet
all the other reflector requirements of this title.

(d)  Clearance lamps shall be mounted so as to indicate the
extreme width of the motor vehicle, not including mirrors, and as
near the top of the vehicle as practicable.

(E)  When rear identification lamps are mounted at the
extreme height of the vehicle, rear clearance lamps may be
mounted at an optional height.

(F)  When mounting of front clearance lamps at the highest
point of a trailer results in those lamps failing to mark the
extreme width of the trailer, they may be mounted at an optional
height, but must indicate the extreme width of the trailer.

(G)  Clearance lamps on truck tractors shall be so located
as to indicate the extreme width of the truck tractor cab.

[(e)] (H) Clearance lamps and side marker lamps may be
mounted in combination if illumination is given as required in
this subtitle with reference to both. However, no clearance lamp
may be combined with any tail lamp or identification lamp.

22-211.