(c) Every motorcycle shall be equipped with two rearview mirrors, one each
attached to the right and left handlebars, which shall meet APPLICABLE FEDERAL
MOTOR VEHICLE SAFETY standards [adopted by the Administrator].

(d) Where the view through the inside rearview mirror is obstructed, two
outside rearview mirrors are required.

22-405.3.

If a new Class A passenger vehicle is sold in this State, the manufacturer shall
equip the vehicle with a spare tire that conforms with the requirements in § 22-405 of
this subtitle, unless:

(1) The tire-wheel system of the vehicle provides a run-flat capability by
which a partially inflated driving surface becomes available in the event of a tire
failure; or

(2) Technological improvements, [determined by the Administrator to be
equivalent to paragraph (1)] CONSISTENT WITH APPLICABLE FEDERAL MOTOR
VEHICLE SAFETY STANDARDS, become available.

22-412.

(a) Every motor vehicle registered in this State and manufactured or
assembled after June 1, 1964, shall be equipped with two sets of seat belts on the
front seat of the vehicle.

(b) Every motor vehicle registered in this State and manufactured or
assembled with a rear seat after June 1, 1969, shall be equipped with two sets of seat
belts on the rear seat of the vehicle.

(c) A person may not sell or offer for sale any vehicle in violation of this
section.

(d) For the purpose of this section only, "motor vehicle" does not include any
motorcycle, bus, truck, or taxicab.

(e) For the purpose of this section only, "seat belt" means any belt, strap,
harness, or like device.

(f) A seat belt may not be sold or offered for sale for use in connection with the
operation of a motor vehicle in this State after June 1, 1964, unless it meets [the
current standards and specifications of the Society of Automotive Engineers
applicable to these belts or other standard adopted by the Administrator]
APPLICABLE FEDERAL MOTOR VEHICLE SAFETY STANDARDS.

SECTION 2. AND BE IT FURTHER ENACTED, That this Act shall take effect
October 1, 1999.