|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1093
|
|
|
|
|
MARVIN MANDEL, Governor
|
|
|
|
|
|
|
|
|
|
|
|
|
|
(B) FRONT AND REAR CLEARANCE LAMPS AND
IDENTIFICATION LAMPS SHALL BE CAPABLE OF BEING SEEN AND
DISTINGUISHED UNDER NORMAL ATMOSPHERIC CONDITIONS, AT THE
TIMES LIGHTS ARE REQUIRED, AT ALL DISTANCES BETWEEN 500
AND 50 FEET FROM THE FRONT AND REAR, RESPECTIVELY, OF THE
VEHICLE.
(C) SIDE MARKER LAMPS SHALL BE CAPABLE OF BEING
SEEN AND DISTINGUISHED UNDER NORMAL ATMOSPHERIC
CONDITIONS, AT THE TIMES LIGHTS ARE REQUIRED, AT ALL
DISTANCES BETWEEN 500 AND 50 FEET FROM THE SIDE OF THE
VEHICLE ON WHICH THEY ARE MOUNTED.
REVISOR'S NOTE: This section presently appears as
Art. 66 1/2, §12-211.
Except for minimal changes in style and
nomenclature, this section has not been
revised; see General Revisor's Note to this
title.
22-212. OBSTRUCTED LAMPS NOT REQUIRED TO BE LIGHTED.
WHENEVER MOTOR AND OTHER VEHICLES ARE OPERATED IN
COMBINATION DURING THE TIME THAT LIGHTS ARE REQUIRED, ANY
LAMP (EXCEPT TAIL LAMPS) THAT, BY REASON OF ITS LOCATION
ON A VEHICLE OF THE COMBINATION, WOULD BE OBSCURED BY
ANOTHER VEHICLE OF THE COMBINATION, NEED NOT BE LIGHTED.
HOWEVER, THIS DOES NOT AFFECT THE REQUIREMENT THAT
LIGHTED CLEARANCE LAMPS BE DISPLAYED ON THE FRONT OF THE
FOREMOST VEHICLE REQUIRED TO HAVE CLEARANCE LAMPS, NOR
THAT ALL LIGHTS REQUIRED ON THE REAR OF THE REARMOST
VEHICLE OF ANY COMBINATION BE LIGHTED.
REVISOR'S NOTE: This section presently appears as
Art. 66 1/2, §12-212.
Except for minimal changes in style and
nomenclature, this section has not been
revised; see General Revisor's Note to this
title.
22-213. LAMPS, REFLECTORS, AND FLAGS ON PROJECTING
LOADS.
(A) ANY VEHICLE CARRYING A LOAD THAT EXTENDS BEYOND
THE SIDE OR TO THE REAR 4 OR MORE FEET BEYOND THE BED OR
BODY OF THE VEHICLE SHALL BE EQUIPPED WITH THE LAMPS AND
REFLECTORS REQUIRED BY THIS SECTION, IN ADDITION TO OTHER
REQUIRED LAMPS, AT THE TIMES SPECIFIED IN §22-201.1 OF
THIS SUBTITLE.
(B) LOADS PROJECTING BEYOND SIDES OF MOTOR VEHICLES
SHALL BE MARKED AS FOLLOWS:
(1) THE FOREMOST EDGE OF THE PROJECTING LOAD,
AT ITS OUTERMOST EXTREMITY, SHALL BE MARKED WITH AN AMBER
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
 |
