Volume 709, Page 2587 View pdf image |
2587 Threaded joints shall not be over-tightened; said (b) Joints may be made by caulking with lead and oakum, or by use of a compression gasket (c) Two (2) pipes with the same outside diameter may be joined with an approved (3) "Section 401.9 PLASTIC PIPE TO METAL A compression type fitting shall be (4) "Section 8 06 STRAINS AND STRESSES 806.1 INSTALLATION OF PIPE Piping in a plumbing system shall be so installed as to prevent undue strains and 806.2 EXPANSION_______AND CONTRACTION Provision shall be made for expansion of piping and for structural settlement that (5) "Section 901.1 (b) ACID WASTE Acid and chemical waste pipes, vent pipes, and fittings shall be of materials unaffected (6) "Section 1600.8 (g) Seepage pits shall be no closer than three (3) times the diameter of the largest pit |
||||
Volume 709, Page 2587 View pdf image |
Tell Us What You Think About the Maryland State Archives Website!
|
An Archives of Maryland electronic publication.
For information contact
mdlegal@mdarchives.state.md.us.